The OneUp Components EDC Threadless Carrier no tap install option lets you store the EDC V2 Tool inside your stem/steerer tube without threading your steerer tube. EDC Tool sold separately.The Threadless Carrier replaces your star nut and lets you preload your headset with a bolt, while also creating a space for the EDC Tool.Easy to install in less than 10 minutes. Install Instructions.Available in 8 colours: (Black, Red, Green, Blue, Orange, Purple, Gold & Oil Slick).Compatible with EDC V2 Tool (You must use the small EDC V2 Storage Capsule with the Threadless Carrier.) The tire plug and bacon strips fit within the small storage capsule.THE FOLLOWING EDC TOOLS ARE NOT COMPATIBLE WITH THE THREADLESS CARRIER SETUP.Chain pliers are not compatible with the threadless carrier set up.The EDC Threadless Carrier does NOT support the CO2 cartridge carrier feature on the EDC ToolThe EDC Threadless Carrier is NOT compatible with V1 EDC Tools (Green Multi-Tool)ENSURE YOUR FORK IS COMPATIBLE – VERY IMPORTANTIncompatible forks: Fox 38 with Oval steerer (Use EDC Threaded Top Cap), Fox E-bike specific Forks, RockShox 35 Forks, RockShox Judy Forks, RockShox eMTB Domain forks, Giant Overdrive 2 Forks. Cannondale Lefty Forks. Carbon SteerersSTEERER TUBE LENGTHMost forks are compatible, except for a small number of forks with very short steerer tubes. For the following cases your fork steerer tube length must meet the minimum length requirement.Fox Forks = 190mm min.RockShox Forks = 220mm min.All other compatible forks = 190mm min.Measure from the underside of your fork crown to the top of your spacer stack, or top of your stem if you are not running any spacers above your stem. OneUp Components EDC Threadless Carrier – How To Measure
